Replacing the system fan and heat sink assembly – Dell Studio One 19 (1909, Early 2009) User Manual
Page 43
10.
Lift the assembly away from the system board and place it in a secure location.
Replacing the System Fan and Heat Sink Assembly
1.
Follow the procedures in
Before You Begin
.
2.
To replace the system fan and heat sink assembly, connect the system fan cable to the connector (SYS_FAN1) on the system board.
3.
Tighten the two captive screws securing the heat sink to the system board.
4.
Replace the three screws securing the system fan to the system board.
5.
Replace the back I/O panel (see
Replacing the Back I/O Panel
).
6.
Replace the stand (see
Replacing the Stand
).
7.
Replace the shield (see
Replacing the Shield
).
8.
Replace the computer cover (see
Replacing the Computer Cover
).
Back to Contents Page
1
heat sink captive screws (2)
2
system fan screws (3)
3
system fan cable