Dell Studio One 19 (1909, Early 2009) - Manual (Page 5)

6. Replace the shield (see Replacing the Shield ).
7. Replace the computer cover (see Replacing the Computer Cover ).
Removing the RF Module
1. Follow the instructions in Before You Begin .
2. Remove the computer cover (see Removing the Computer Cover ).
3. Remove the shield (see Removing the Shield ).
4. Remove the stand (see Removing the Stand ).
5. Remove the back I/O panel (see Removing the Back I/O Panel ).
6. Remove the processor fan (see Removing the Processor Fan ).
7. Remove the right speaker (see Removing the Right Speaker )
8. Remove the optical drive (see Removing the Optical Drive ).
9. Remove the screw securing the radio frequency (RF) module, flip the module and disconnect the RF module cable.
Replacing the RF Module
1. Follow the instructions in Before You Begin .
2. To install the RF module, connect the RF module cable.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
1 RF module cable 2 RF module
3 screw