Dell XPS 710 - Manual (Page 5)

System Setup
Overview
Use system setup as follows:
l To change the system configuration information after you add, change, or remove any hardware in your computer
l To set or change a user-selectable option such as the user password
l To read the current amount of memory or set the type of hard drive installed
Before you use system setup, it is recommended that you write down the system setup screen information for future reference.
Entering System Setup
1. Turn on (or restart) your computer.
2. When the DELL logo appears, press <F2> immediately.
If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft® Windows® desktop, then shut down your
computer and try again.
System Setup Screens
The system setup screen displays current or changeable configuration information for your computer. Information on the screen is divided into three areas: the
options list, the active options field, and key functions.
Environmental
Temperature:
Operating 10° to 35°C (50° to 95°F)
Storage –40° to 65°C (–40° to 149°F)
Relative humidity 20% to 80% (noncondensing)
Maximum vibration:
Operating 0.25 G at 3 to 200 Hz at 0.5 octave/min
Storage 0.5 G at 3 to 200 Hz at 1 octave/min
Maximum shock:
Operating bottom half-sine pulse with a change in velocity of 20
inches/sec (50.8 cm/sec)
Storage 27-G faired square wave with a velocity change of
200 inches/sec (508 cm/sec)
Altitude:
Operating – 15.2 to 3048 m (–50 to 10,000 ft)
Storage – 15.2 to 10,668 m (–50 to 35,000 ft)
NOTICE: Do not change the settings in system setup unless you are an expert computer user. Certain changes can cause your computer to work
incorrectly.
NOTE: Keyboard failure may result when a key on the keyboard is held down for extended periods of time. To avoid possible keyboard failure,
press and release <F2> in even intervals until the system setup screen appears.
Options List — This field appears on the left side of
the system setup window. The field is a scrollable list
containing features that define the configuration of
your computer, including installed hardware, power
conservation, and security features.
Scroll up and down the list with the up- and down-
arrow keys. As an option is highlighted, the Options
Field displays more information about that option
and the option's current and available settings.
Options Field — This field appears on the right side
of the system setup window and contains information
about each option listed in the Options List. In this
field you can view information about your computer
and make changes to your current settings.
Press the left- and right-arrow keys to highlight an
option. Press <Enter> to make that selection active
and return to the Options List.
NOTE: Not all settings listed in the Options Field are
changeable.