Connecting monitors, Connecting a monitor (without an adapter) – Dell XPS 710 User Manual
Page 71
4.
Ensure that the screw hole on the stand is aligned with the screw hole on the base of the computer.
5.
Insert the captive screw into the screwhole, then tighten the screw to secure the stand to the base of the computer.
6.
With the help of an assistant, carefully set the computer upright.
7.
Carefully, lift the rear of the computer and slide the stabilizing feet outward into the open position.
Connecting Monitors
Connecting a Monitor (Without an Adapter)
1
captive screw
2
stabilizing feet (closed)
3
computer stand
4
slots (6)
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
To reduce the risk of fire, electric shock, or injury, do not overload an electrical outlet, power strip, or convenience receptacle. The
total ampere rating of all products plugged into an electrical outlet, power strip, or other receptacle should not exceed 80 percent of the branch
circuit rating.
NOTE:
Depending on the options selected when you purchased your computer, your video card may have two DVI ports, or one DVI and one VGA port.
1 DVI (white) connector
2 TV-OUT connector
3 VGA (blue) connector
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.