Dell AXIM X30 - Manual (Page 107)

Getting Connected 107
To start using LEAP, perform the following steps.
1 Obtain the following information from your network administrator:
•
Network name
• Association mode
• Encryption method
2 From the Odyssey Client window, tap on Settings → Configure → Add.
3 Enter the network name (SSID) if known, or tap on Scan to search the
available Access Points. Tap Ok.
4 LEAP will only support an infrastructure network, so do not change the
default settings in the drop-down menu. Tap Next.
5 Fill in Association Mode and Encryption method. Tap Next.
6 EAP/TTLS is the preselected EAP type. Tap Add and select
EAP/LEAP in the window that opens up.
7 Unless you have an authentication certificate to use TTLS and have
configured your system to support it, remove EAP/TTLS. Tap Next.
NOTE:
Failure to remove EAP/TTLS when it is not properly set up may
prevent your wireless security system from functioning.
8 Enter user name and password. Tap Next.
9 Tap Finish to complete LEAP configuration.
10 Tap OK.
11 Select the network that you added from the drop down menu and tap
the box beside Connect to, leaving a check mark. Status will display as
connected (authenticated) when this process is complete.
NOTE:
For further details, please refer to the Odyssey Client help file included
in your device. You can access the help file at Start
→
Help
→
Odyssey Client for
Pocket PC.
U7216bk0.book Page 107 Thursday, September 30, 2004 2:03 PM