Dell PowerEdge 6950 User Manual
Page 88
Advertising
88
Installing System Components
9 Remove the SAS backplane:
a
Pull the spring-loaded blue retention pin away from the front of the backplane, then slide the
backplane upward. See Figure 3-26.
b
When the backplane cannot slide upward any farther, pull the backplane toward the back of the
system to remove it from the retention hooks.
c
Lift the board out of the system, being careful to avoid damaging components on the face of the
board.
d
Place the SAS backplane face down on a work surface.
Figure 3-26.
Removing and Installing the SAS Backplane
1
retention pin
2
SAS backplane
3
control-panel cable connector
4
installation alignment slot
5
retention slots (7)
5
4
3
1
2
Advertising