Dell PowerEdge 6950 - Manual (Page 93)

Installing System Components
93
Figure 3-30. Removing and Installing the System Board
Installing the System Board
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1 Transfer the processors to the new system board. See Figure 6-2 for the location of the system board
connectors.
NOTE:
Do not install the heat sinks at this time.
2 Remove the memory modules and transfer them to the same locations on the new board. See
"Removing Memory Modules" on page 61 and "Installing Memory Modules" on page 60.
3 Install the new system board:
a Lower the right side of the system board into the chassis.
b Slowly lower the left side of the system board into the chassis.
1 system board 2 retention slots 3 retention hooks
4 retention pin
4
1
2
3