Dell C2660dn Color Laser Printer - Manual (Page 176)

Reset Passphrase Resets the pass phrase.
WPS Setup Configures the Wi-Fi Direct network using WPS.
Push Button Control Configures the Wi-Fi Direct network with WPS-PBC.
PIN Code Configures the Wi-Fi Direct network using PIN code assigned
automatically by the printer.
PIN Code Displays the current PIN code only when WPS Setup is set to PIN Code.
Print PIN Code Prints the PIN code. Confirm it when entering PIN assigned to the printer
into your Wi-Fi mobile device.
Reset PIN Code Resets the PIN code.
Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the
printer is turned off and then on again.
Values:
Auto * Detects the Ethernet settings automatically.
10BASE- T Half Uses 10BASE-T Half-duplex.
10BASE- T Full Uses 10BASE-T Full-duplex.
100BASE- TX Half Uses 100BASE-TX Half-duplex.
100BASE- TX Full Uses 100BASE-TX Full-duplex.
1000BASE- T Full Uses 1000BASE-T Full-duplex.
TCP/IP
Purpose:
To configure TCP/IP settings.
Values:
IP Mode Dual Stack * Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv6 Mode Uses IPv6 to set the IP address.
IPv4 Get IP Address AutoIP * Sets the IP address automatically. A random value in the range of
169.254.1.0 to 169.254.254.255 that is not currently in use on the
network is set as the IP address. The subnet mask is set as
255.255.0.0.
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel Use this option when you want to set the IP address manually on
the operator panel.
IP Address When an IP address is being set manually, the IP is allocated to the
printer using the format nnn.nnn.nnn.nnn. Each octet that makes
up nnn.nnn.nnn.nnn is a value in the range of 0 to 254. 127 and
any value in the range of 224 to 254 cannot be specified for the
first octet of a gateway address.
Understanding the Printer Menus 174