Dell OptiPlex 3010 (Mid 2012) - Manual (Page 27)

7. Remove the Input/Output panel.
Related Links
Installing The Input/Output Panel
Installing The Input/Output Panel
1. Insert the Input/Output panel into the slot on the chassis front.
2. Slide the Input/Output panel towards the left of the computer to secure to the chassis.
3. Tighten the screw to secure the Input/Output panel to the chassis.
4. Connect the Input/Output panel or the FlyWire cable to the system board.
5. Install the front bezel .
6. Install the cover .
7. Follow the procedures in After Working Inside Your Computer .
Related Links
Removing The Input/Output Panel
Removing The Power Supply
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the cover .
3. Remove the PSU thermal sensor .
4. Disconnect the 4–pin power cable from the system board.
27