Dell POWEREDGE M1000E - Manual (Page 53)

Access Gateway Administrator’s Guide 33
53-1002743-01
D_Port support
2
Saving port mappings
Before configuring D_Ports, you must remove all mappings between the subject ports and device
as they will not be retained. This includes port (N_Port to F_Port), device (WWN), static, and
dynamic mapping. You can save N_Port mappings using Fabric OS commands. Once you save the
mappings, you can display them so that you can manually reconfigure them after the D_Port is
disabled. A command is also available to delete saved N_Port mappings. The following are
available backup mapping commands. For more details, refer to the Fabric OS Command
Reference.
• To save configured N_Port mappings, enter the following command:
ag --backupmappingsave N_Port
• To display saved N__Port mappings so that you can reconfigure them on the switch, enter the
following command:
ag --backupmappingshow N_Port
Following is an example of command output:
sw0:root>ag --backupmappingshow 44
Configured static and prefered mappings haved been saved for the N_port
successfully
N_Port 44
Backed-up Configured F_Ports 20:21:22
Backed-up Static F_Ports 23:24
Backed-up Preferred F_Ports 26:27:28:29
• To delete configured N_Port mappings, enter the following command:
ag --backupmappingdel N_Port