Dell POWEREDGE 1855 User Manual
Page 5
4.
Use a small plastic scribe to move the password switch 1 to the "off" position.
to locate the password switch 1 on the server module board.
5.
If you removed a daughter card from the server module board, reinstall it. See "
Installing a Daughter Card
" in "Installing System Options."
6.
Close the server module. See "
Closing the Server Module
" in "Installing System Options."
7.
Install the server module. See "
Installing a Server Module
" in "Installing System Options."
When the server module is on, the power-on indicator is solid green. Allow the server module to finish booting.
The existing passwords are not disabled (erased) until the system boots with the password switch 1 to the "off" position. However, before you assign a
new system and/or setup password, you must move the password switch 1 to the "on" position.
8.
Remove the server module. See "
Removing a Server Module
" in "Installing System Options."
9.
Open the server module. See "
Opening the Server Module
" in "Installing System Options."
10.
If a daughter card is installed on the server module board, remove the daughter card. See "
Removing a Daughter Card
" in "Installing System Options."
11.
Use a small plastic scribe to move the password switch 1 to the "on" position.
to locate the password switch 1 on the server module board.
12.
If you removed a daughter card from the server module board, reinstall it. See "
Installing a Daughter Card
" in "Installing System Options."
13.
Close the server module. See "
Closing the Server Module
" in "Installing System Options."
14.
Install the server module. See "
Installing a Server Module
" in "Installing System Options."
15.
Assign a new system and/or setup password.
To assign a new passwords using the System Setup program, see your User's Guide.
Back to Contents Page
NOTE:
If you assign a new system and/or setup password with the switch 1 still in to the "off" position, the system disables the new password(s)
the next time it boots.