Dell DX6000 - Manual (Page 46)

48 Disaster Recovery
3 Install the DX Cluster Services Node software by running the
self-extracting script from inside the bundle directory location where the
shell script was unzipped.
This initiates installation of the DX Cluster Services Node software and its
dependent packages. For more information, see the Cluster Services Node
Installation and Configuration Guide at support.dell.com/manuals.
4 Eject the operating system media from the optical drive using the
following command:
# eject /media/dvd
5 Reboot the DX6a00 system when the installation completes.
Use the following command to reboot the system:
# reboot
Configuring the DX Cluster Services Node
Software
After installing and rebooting the DX Cluster Services Node, you are
automatically prompted to enter some minimal configuration data to
configure and deploy the DX Cluster Services Node. This configuration
process is required only once after the initial installation. Any necessary
updates to the parameters entered during this initial boot process can be
made from the Cluster Services Node Console. For more information about
configuring the Cluster Services node, see the Cluster Services Node
Installation and Configuration Guide at support.dell.com/manuals.
Restoring the Cluster Configurations
Previous cluster configuration files can be restored through the Cluster
Services Node Console (Cluster Services TAB Backup and Restore). For more
information on restoring cluster configurations, see the Cluster Services Node
Installation and Configuration Guide at support.dell.com/manuals.
Bringing Up the DX Storage Cluster
Turn on the storage nodes in your cluster. Each storage node network boots
from a DX Storage Node image located on the DX Cluster Services Node.
book.book Page 48 Monday, October 17, 2011 3:42 PM