Dell Vostro 200 (Mid 2007) - Manual (Page 127)

Removing and Installing Parts
127
6 Press in on the securing tab on the side of the drive and slide the drive up
and out.
7 If removing this drive changes the drive configuration, then be sure to
reflect these changes in system setup. When you restart your computer,
enter system setup (see "System Setup" on page 170), then go to the
"Drives" section of the System Setup and under Drive 0 through 3, set the
Drive to the correct configuration.
8 Replace the support bracket (see "Replacing the Support Bracket" on
page 161).
9 Replace the computer cover (see "Replacing the Computer Cover" on
page 162).
10 Connect computer and other devices to an electrical outlet.
1 hard drive 2 serial ATA data cable 3 power cable
4 system board connector 5 securing tab 6 shoulder
screws (4)
2
4
3
1
6
5