Dell Vostro 200 (Mid 2007) User Manual
Page 83
Troubleshooting Tools
83
N
O
BOOT
DEVICE
AVAILABLE
—
No bootable partition on hard drive, no bootable
floppy in floppy driver, the hard drive or floppy cable is loose, or no bootable device
exists.
• If the floppy drive is your boot device, ensure that a bootable floppy disk is in the
drive.
• If the hard drive is your boot device, ensure that the cables are connected and
that the drive is installed properly and partitioned as a boot device.
• Enter system setup and ensure that the boot sequence information is correct.
See "Entering System Setup" on page 170.
N
O
TIMER
TICK
INTERRUPT
—
A chip on the system board might be
malfunctioning or motherboard failure. See "Contacting Dell" on page 183 for
assistance.
N
ON
-
SYSTEM
DISK
OR
DISK
ERROR
—
Replace the floppy disk with one that has
a bootable operating system or remove the floppy disk from drive A and restart the
computer.
N
OT
A
BOOT
DISKETTE
—
Insert a bootable floppy disk and restart your computer.
U S B
OVER
CURRENT
ERROR
—
Disconnect the USB device. Use external power
source for the USB device.
N O T I C E - H
ARD
D
RIVE
S E L F M O N I T O R I N G S Y S T E M
HAS
REPORTED
THAT
A
PARAMETER
HAS
EXCEEDED
ITS
NORMAL
OPERATING
RANGE
. D
ELL
RECOMMENDS
THAT
YOU
BACK
UP
YOUR
DATA
REGULARLY
. A
PARAMETER
OUT
OF
RANGE
MAY
OR
MAY
NOT
INDICATE
A
POTENTIAL
HARD
DRIVE
PROBLEM
. —
S.M.A.R.T error or possible hard drive failure. This feature can be enabled or
disabled in the BIOS setup.