Dell Vostro 200 (Mid 2007) - Manual (Page 148)

148
Removing and Installing Parts
Installing the I/O Panel
1 Place the I/O panel into the slot.
NOTICE:
Take care not to damage the cable connectors and the cable routing clips
when sliding the I/O panel into the computer.
2 Replace and tighten the screw that secures the I/O panel to the chassis.
3 Reconnect the cables to the system board.
4 Replace the bezel (see "Replacing the Bezel" on page 123).
5 Replace the computer cover (see "Replacing the Computer Cover" on
page 162).
6 Connect your computer and devices to an electrical outlet, and turn them
on.
7 Verify that the computer works correctly by running the Dell Diagnostics
(see "Dell Diagnostics" on page 84).
1 I/O panel 2 screw
2
1