Dell OptiPlex 330 (Late 2007) - Manual (Page 51)

7. If you are replacing the floppy drive, see Installing a Floppy Drive . Otherwise, replace the drive panel by aligning its hinges and rotating it up until it
snaps into place.
8. Replace the bezel (see Replacing the Bezel ).
9. Replace the computer cover (see Replacing the Computer Cover ).
10. Connect your computer and devices to electrical outlets, and then turn them on.
11. Check the system setup for the appropriate diskette Drive Option changes (see Entering System Setup ).
Installing a Floppy Drive
1. Follow the procedures in Before You Begin .
2. Remove the computer cover (see Removing the Computer Cover ).
3. Remove the bezel (see Removing the Bezel ).
4. If you are replacing a floppy drive, remove the shoulder screws from the existing drive and attach the screws to the replacement drive.
5. If you are installing a new floppy drive:
a. Remove the drive-panel insert for your new drive (see Drive-Panel Inserts ).
b. Remove the shoulder screws from the inside of the drive-panel insert.
c. Attach the screws to the new drive.
6. Align the shoulder screws on the floppy drive with the shoulder screw slots, and gently slide the drive into the bay until it clicks into place.
1 floppy drive 2 drive release latch
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.