Dell OptiPlex 330 (Late 2007) - Manual (Page 88)

6. Attach the power and data cables to the floppy drive.
7. Gently slide the floppy drive into place into slot 2.
8. Align the shoulder screws with the screw guides, and slide the drive into the bay until it clicks into place.
9. Connect the other end of the data cable to the connector labeled "FLOPPY" on the system board (see System Board Components ).
10. Replace the optical drive (see Optical Drive ).
11. Replace the computer cover (see Replacing the Computer Cover ).
12. Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
13. Enter system setup (see Entering System Setup ) and select the appropriate Diskette Drive option.
14. Verify that your computer works correctly by running the Dell Diagnostics (see Dell Diagnostics ).
Optical Drive
Removing an Optical Drive
1. Follow the procedures in Before You Begin .
1 slot verification number
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, laceration by moving fan blades, or other unexpected injuries, always unplug your computer from
the electrical outlet before removing the cover.
NOTICE: Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to cables and the cable connectors.