Dell OptiPlex 330 (Late 2007) - Manual (Page 52)

7. Attach the power and data cables to the floppy drive.
8. Connect the other end of the data cable to the connector labeled "FLOPPY" on the system board (see System Board Components ) and route the cable
through the clip on the shroud.
9. Replace the bezel (see Replacing the Bezel ).
10. Check all cable connections, and fold cables out of the way to avoid blocking airflow between the fan and cooling vents.
11. Replace the computer cover (see Replacing the Computer Cover ).
12. Connect your computer and devices to their electrical outlets, and turn them on.
13. Enter system setup (see Entering System Setup ) and select the appropriate Diskette Drive option.
14. Verify that your computer works correctly by running the Dell Diagnostics (see Dell Diagnostics ).
1 floppy drive 2 shoulder screws (4)
3 shoulder screw slots (2)
1 power cable 2 floppy-drive cable
3 floppy-drive connector (FLOPPY)
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.