Dell OptiPlex 330 (Late 2007) - Manual (Page 86)

6. Connect the power and data cables to the drive.
7. Locate the correct slot for the drive, and slide the drive into the bay until it clicks into place.
8. Replace the floppy drive and optical drive.
9. Connect the data cable to the system board.
10. Check all cables to be certain that they are properly connected and firmly seated.
11. Replace the computer cover (see Replacing the Computer Cover ).
12. Connect your computer and devices to electrical outlets, and then turn them on.
13. Partition and logically format your drive before you proceed to the next step.
14. Check the system setup for drive configuration changes (see Entering System Setup ).
15. Test the hard drive by running the Dell Diagnostics. (see Dell Diagnostics ).
16. Install your operating system on the hard drive. For instructions, see the documentation that came with your operating system.
Floppy Drive
1 securing tabs (2) 2 drive
3 release tabs (2) 4 plastic hard-drive bracket
1 hard drive 2 slot verification number
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, laceration by moving fan blades, or other unexpected injuries, always unplug your computer from
the electrical outlet before removing the cover.