Dell PowerEdge RAID Controller H200 - Manual (Page 35)

Driver Installation
35
Installing a Windows Server 2003, Windows Server 2008 or Windows
Server 2008 R2 Driver for a New RAID Controller
Perform the following steps to configure the driver for the RAID controller on
a system that already has Windows installed:
1 Turn off the system.
2 Install the new RAID controller in the system.
3 Turn on the system.
The Windows operating system detects the new controller and displays a
message to inform you.
4 The Found New Hardware Wizard screen displays the detected hardware
device.
5 Click Next.
6 On the Locate device driver screen, select Search for a suitable driver for
my device and click Next.
7 Make the Driver Files available and browse to the proper location from the
Locate Driver Files screen.
8 Click Next.
9 The wizard detects and installs the appropriate device drivers for the new
RAID controller.
10 Click Finish to complete the installation.
11 Reboot the system if Windows request to do so.
NOTE:
The Windows Server 2008 R2 operating system includes a device driver to
support the SAS controllers. The system automatically detects the new controller
and installs the driver. Check the version of the driver installed by Windows and
update if necessary.
PERC H200.book Page 35 Tuesday, July 13, 2010 4:15 PM