Dell PowerEdge RAID Controller H200 - Manual (Page 51)

PERC H200 and 6Gbps SAS HBA BIOS
51
Exit Screen
It is important to exit the SAS BIOS Configuration Utility properly,
because some changes take effect only when you exit. From the Adapter List,
press <Esc> to exit. In addition, a similar exit screen appears when you
exit most other screens, and it can be used to save settings.
Performing Configuration Tasks
The following configuration tasks can be performed using a PERC H200 card:
• Creating a RAID 0, RAID 1, or RAID 10 virtual disk
• Viewing virtual disk properties
• Activating a virtual disk
• Migrating and Activating a virtual disk
• Hot Spare failover
• Replacing and Rebuilding a degraded virtual disk
• Assigning a Preferred Boot Device
Consistency
Check This option is used to run a consistency check on a
redundant RAID volume.
This option is grayed out under the following conditions:
• The volume is RAID 0
• The volume is not optimal
• The volume has a consistency check pending
• The volume is already running a consistency check
Activate
Volume This option is used to activate an inactive (foreign) volume. The option
is grayed out if there are no inactive arrays.
Delete
Volume This option is used to delete the currently displayed volume.
Table 6-3. Manage Volume Field Descriptions (continued)
Field Description
PERC H200.book Page 51 Tuesday, July 13, 2010 4:15 PM