Dell B5460dn Mono Laser Printer - Manual (Page 104)

Use To
Output Lighting
Normal/Standby Mode
Off
Dim
Bright
Set the amount of light from the bin.
Notes:
• If Eco-Mode is set to Energy or Energy/Paper, then the
factory default setting is Dim.
• If Eco-Mode is set to Off or set to Paper, then the factory
default setting is Bright.
• This menu appears only when an indicator light is installed
on the bin or when an optional bin with an indicator light is
added.
Alarms
Alarm Control
Cartridge Alarm
Staple Alarm
Hole Punch Alarm
Set an alarm when the printer requires user intervention.
When activated, Alarm Control lets you set the number of times
that the alarm sounds, while Cartridge Alarm lets you stop printing
when a cartridge-low condition occurs.
For each alarm type, select from the following options:
Off
Single
Continuous
Notes:
• Off is the factory default setting for Cartridge Alarm, Staple
Alarm, and Hole Punch Alarm. This means no alarm will
sound.
• Single is the factory default setting for Alarm Control. This
sounds three quick beeps.
• Continuous repeats three beeps every 10 seconds.
Timeouts
Sleep Mode
Disabled
1–120
Set the amount of time the printer waits after a job is printed before
it goes into a reduced power state.
Notes:
• 20 is the factory default setting.
• Disabled appears only when Energy Conserve is set to Off.
• Lower settings conserve more energy, but may require
longer warm
‑up times.
• Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm
‑up time.
Timeouts
Print with Display Off
Allow printing with display off
Display on when printing
Allow the printer to print even when the display is off.
Note: “Allow printing with display off” is the factory default
setting.
Understanding the printer menus 104