Dell B5460dn Mono Laser Printer - Manual (Page 84)

Use To
Portrait Width
3–8.5 inches
76–216 mm
Set the portrait width.
Notes:
• If the width exceeds the maximum, then the printer uses the
maximum width allowed.
• 8.5 inches is the US factory default setting. You can increase the
width in 0.01
‑inch increments.
• 216 mm is the international factory default setting. You can increase
the width in 1
‑mm increments.
Portrait Height
3–14.17 inches
76–360 mm
Set the portrait height.
Notes:
• If the height exceeds the maximum, then the printer uses the
maximum height allowed.
• 14 inches is the US factory default setting. You can increase the
height in 0.01
‑inch increments.
• 356 mm is the international factory default setting. You can increase
the height in 1
‑mm increments.
Feed Direction
Short Edge
Long Edge
Specify the feed direction if the paper can be loaded in either direction.
Notes:
• Short Edge is the factory default setting.
• Long Edge appears only when the longest edge is shorter than the
maximum width supported in the tray.
Bin Setup menu
Use To
Output Bin
Standard Bin
Bin [x]
Specify the default bin.
Notes:
• If multiple bins are assigned the same name, then the
name appears only once in the menu.
• Standard Bin is the factory default setting.
Understanding the printer menus 84