Dell LATITUDE D400 - Manual (Page 18)

Replacing the Interposer
1. Attach the hard drive carrier to the new hard drive, and replace the two M3 x 3-mm screws.
2. Carefully attach the interposer from the old hard drive by pushing it straight onto the hard drive. Ensure that the pins are oriented correctly. When the
interposer is attached correctly, four extra pins are on one side.
3. Install the hard drive .
Back to Contents Page
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the connector.
1 interposer 8267R