Dell LATITUDE D400 - Manual (Page 32)

Back to Contents Page
Palm Rest
1. Follow the instructions in " Preparing to Work Inside the Computer " to remove the battery and prepare the computer for work.
2. Remove the hard drive .
3. Remove the keyboard .
4. Remove the display .
5. Turn the computer over and remove the nine M2.5 x 6-mm screws.
6. Remove the two M2 x 1.8-mm screws located inside the battery bay.
7. Turn the computer over and remove the four M2.5 x 6-mm screws.
CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: You must remove the display assembly before you remove the palm rest; the display hinges pass through the back of the palm rest.
1 M2 x 1.8-mm screws (2) 5H953
2 M 2.5 x 6-mm screws (9) 4911U