See also, Dpm server software prerequisites – Dell PowerVault DP600 User Manual
Page 15
15
4. After installation is complete, apply all available Windows Server 2003 service packs and
updates, including Windows Server 2003 Service Pack 2 (SP2).
All Windows updates are available from
(http://go.microsoft.com/fwlink/?LinkID=451).
Windows Server 2003 SP2 is available from
(http://go.microsoft.com/fwlink/?LinkID=90633).
See Also
DPM Server Software Prerequisites
The System Center Data Protection Manager (DPM) server must be a dedicated, single-purpose
server, and it cannot be either a domain controller or an application server. The DPM server
cannot be the management server for Microsoft Operations Manager (MOM) 2005 or Microsoft
System Center Operations Manager 2007.
Before you install DPM, you must install the following:
• Knowledge Base article 940349,
(http://go.microsoft.com/fwlink/?LinkId=99034).
Note
After installing Knowledge Base article 940349 and then restarting the DPM server and/or
the protected server, we recommend that you refresh the protection agents in DPM
Administration Console. To refresh the agents, in the Management task area, click
the Agents tab, select the computer, and then in the Actions pane, click Refresh
information. If you do not refresh the protection agents, Error ID: 31008 may appear
because DPM only refreshes the protection agents every 30 minutes.
• Windows PowerShell 1.0 from
• Single Instance Storage (SIS) on Windows Server 2008 operating system (Pre-release
version). For information about installing SIS on Windows Server 2008, see
If you want to manually install the required prerequisite software, you must follow the steps
detailed in
Manually Installing Prerequisite Software
Following is the DPM server prerequisite software that DPM Setup installs before installing the
DPM application: