Dell PowerVault DP600 - Manual (Page 26)

26
Server that you want to use and the appropriate administrator credentials, and then
click Next.
Note
If SQL Server Reporting Services is installed on the remote SQL Server,
DPM Setup will use that Reporting Service. If SQL Server Reporting Services
is not installed on the remote computer running SQL Server, you must install
and configure the service on the remote computer running SQL Server
before continuing with DPM Setup.
11. On the Security Settings page, specify and confirm a strong password for the restricted
MICROSOFT$DPM$Acct and DPMR$<computer name> local user accounts, and then
click Next.
For security purposes, DPM runs SQL Server and the SQL Server Agent service under
the MICROSOFT$DPM$Acct account, which DPM Setup creates during DPM
installation. To securely generate reports, DPM creates the DPMR$<computer name>
account.
A strong password is typically defined as a password that is at least six characters long,
does not contain all or part of the user’s account name, and contains at least three of the
following four categories of characters: uppercase characters, lowercase characters,
base 10 digits, and symbols (such as !, @, #).
Note
The password that you specify for these accounts does not expire.
12. On the Microsoft Update Opt-In page, specify if you want to sign up for the Microsoft
Update service, and then click Next.
You can change your Microsoft Update opt-in decision at any time after you install
DPM 2007. To change your Microsoft Update opt-in decision, see the Microsoft Update
Web site (http://go.microsoft.com/fwlink/?LinkId=74122).
13. On the Customer Experience Improvement Program page, specify if you want to enlist
in the Customer Experience Improvement Program (CEIP), and then click Next.
14. On the Summary of Settings page, review the summary of installation settings. To
install DPM using the specified settings, click Install. To change the settings, click Back.
After the installation is complete, the Installation page displays the installation status.
15. Click Close, and then restart the computer to incorporate all of the changes made by
DPM Setup.
Note
This restart is necessary to load the volume filter that DPM uses to track and transfer
block level changes between DPM and the computers it protects, or between the
primary and secondary DPM servers.