Speakers, Removing the speakers – Dell INSPIRON 2600 User Manual
Page 56
Back to Contents Page
Speakers
Dell™ Inspiron™ 2600 and 2650
Removing the Speakers
The speakers are located on the left and right corners of the front of the bottom case. Take note of the speaker cable routing so that you can replace the
cables properly under or between their routing clips.
1.
Remove the
hard drive
.
2.
Remove the
floppy drive
.
3.
Remove the
keyboard
.
4.
Remove the
display assembly
.
5.
Remove the
EMI shield
.
6.
Remove the
video card
.
7.
Remove the
palm rest
.
8.
Disconnect the speaker connector from the system board.
9.
Remove the speaker cables from under or between their routing clips and die casting.
10.
Remove the speakers by pulling them straight up and out of the bottom case.
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and remove any installed battery.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE:
Read "
Preparing to Work Inside the Computer
" before performing the following procedure.
1
speaker connector
7
hard drive cage
2
routing clips (10)
8
left speaker cable
3
battery bay
9
left die casting
4
right speaker
10
left speaker
5
right speaker cable
11
floppy drive cage
6
right die casting
NOTICE:
Remove the speaker cables from their routing clips and die casting with care to avoid damaging the cables.
NOTICE:
Handle the speakers with care to avoid damaging them.