Dell Adamo XPS (Late 2009) - Manual (Page 21)

Replacing the Solid State Drive
1. Follow the instructions in Before You Begin .
2. Remove the new drive from its packaging.
Save the original packaging for storing or shipping the solid state drive.
3. Push the solid state drive until it is fully connected to the connector on the right daughter board.
4. Replace the screw that secures the solid state drive to the computer base.
5. Replace the palm rest assembly (see Replacing the Palm Rest Assembly ).
6. Replace the computer battery (see Replacing the Computer Battery ).
7. Install the operating system for your computer, as needed. See Restoring Your Operating System .
8. Install the drivers and utilities for your computer, as needed.
Back to Contents Page
NOTE: If your existing solid state drive was shipped with a mylar cover, replace the mylar cover on the new drive.
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.