Dell Vostro 410 (Late 2008) - Manual (Page 18)

4. Disconnect the power and data cables from the back of the floppy drive.
5. Disconnect the data cable from the system board.
6. Remove the two screws securing the floppy drive.
7. Slide the floppy drive out through the front of the computer.
8. If you are not replacing the drive, reinstall the drive panel insert (see Media Card Reader ).
9. Replace the bezel (see Replacing the Computer Cover ).
10. Perform the steps in the procedure After Working on Your Computer .
11. Check the system setup for the appropriate diskette Drive Option changes (see Entering System Setup ).
Replacing or Adding a Floppy Drive
1. Follow the procedures in Before Working on Your Computer .
2. Remove the computer cover (see Removing the Computer Cover ).
3. Remove the bezel (see Removing the Bezel ).
4. If you are installing a new floppy drive rather than replacing a drive, remove the break-away metal plate from the FlexBay (see Removing the FlexBay
Break-Away Metal Plate ).
5. Gently slide the floppy drive into place in the FlexBay from the front of the computer.
6. Align the screw holes in the floppy drive with the screw slots on the left side of the FlexBay slot.
7. Tighten the two screws to secure the floppy drive.
8. Attach the power and data cables to the floppy drive.
9. Connect the other end of the data cable to the connector labeled "FLOPPY" on the system board (see System Board Components ).
1 screws (2) 2 floppy drive
3 data cable 4 power cable