Power supply, Removing the power supply, Replacing the power supply – Dell Vostro 410 (Late 2008) User Manual
Page 32
Back to Contents Page
Power Supply
Dell™ Vostro™ 410 Service Manual
Power Supply DC Connector Pin Assignments
Removing the Power Supply
1.
Follow the procedures in
Before Working on Your Computer
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Disconnect the DC power cables from the system board and the drives.
4.
Note the routing of the DC power cables underneath the tabs in the computer chassis as you remove them from the system board and drives. You must
route these cables properly when you replace them to prevent them from being pinched or crimped.
5.
Remove the hard drive cable, CD or DVD drive data cable, front panel ribbon cable, and any other cables from the securing clip on the side of the power
supply.
6.
Remove the four screws that attach the power supply to the back of the computer chassis.
7.
Slide the power supply towards the front of the computer and lift it out.
Replacing the Power Supply
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at the following location:
www.dell.com/regulatory_compliance.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
1
screws (4)
2
power supply