Dell PowerEdge T110 User Manual

Page 22

Advertising
background image

22

About Your System

Caution!

NVRAM_CLR jumper

is installed on

system

board.Please run

SETUP.

NVRAM_CLR jumper is
installed in the clear
setting. CMOS has been
cleared.

Move the NVRAM_CLR
jumper to the default position
(pins 3 and 5). See Figure 6-1
for jumper location. Restart
the system and re-enter the
BIOS settings. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 35.

CPU set to

minimum

frequency.

The processor speed may
be intentionally set lower
for power conservation.

If not an intentional setting,
check other system messages
for possible causes.

Current boot mode

is set to UEFI.

Please ensure

compatible

bootable media is

available. Use

the system setup

program to change

the boot mode as

needed.

The system failed to boot
because UEFI boot mode is
enabled in BIOS and the
boot operating system is
non-UEFI.

Ensure that the boot mode is
set correctly and that the
proper bootable media is
available. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 35.

Decreasing

available

memory.

Faulty or improperly
installed memory modules.

Reseat the memory modules.
See "Troubleshooting System
Memory" on page 113.

Embedded NIC

x

and

NIC

y

:

OS NIC=

<ENABLED

|DISABLED>

,

Management

Shared NIC=

<ENABLED

|DISABLED>

The operating system NIC
interface is set in BIOS.
The Management Shared
NIC interface is set in
management tools.

Check the system
management software or the
System Setup program for
NIC settings. If a problem is
indicated, see
"Troubleshooting a NIC" on
page 107.

Message

Causes

Corrective Actions

Mayzie_HOM.book Page 22 Monday, August 31, 2009 9:33 PM

Advertising