Dell PowerEdge T110 User Manual
Page 86
86
Installing System Components
CAUTION:
Never remove the heat sink from a processor unless you intend to
remove the processor. The heat sink is necessary to maintain proper thermal
conditions.
6 Using a #2 Phillips screwdriver, loosen one of the heat-sink retention
7 Wait 30 seconds for the heat sink to loosen from the processor.
8 Repeat step 6 and step 7 to loosen the other three heat-sink retention
screws.
9 Gently lift the heat sink off of the processor and set the heat sink aside
upside down (thermal grease side facing up).
Figure 3-15.
Installing and Removing the Heat Sink
CAUTION:
The processor is held in its socket under strong pressure. Be aware
that the release lever can spring up suddenly if not firmly grasped.
1
heat sink
2
heat sink retention screws (4)
1
2
Mayzie_HOM.book Page 86 Monday, August 31, 2009 9:33 PM