Vga connector board, Removing the vga connector board, Replacing the vga connector board – Dell Inspiron 13 (N3010, Mid 2010) User Manual
Page 47
Back to Contents Page
VGA Connector Board
Dell™ Inspiron™ N3010 Service Manual
Removing the VGA Connector Board
Replacing the VGA Connector Board
Removing the VGA Connector Board
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the memory-module cover (see
Removing the Memory-Module Cover
).
4.
Remove the memory module(s) (see
Removing the Memory Module(s)
).
5.
Remove the keyboard (see
Removing the Keyboard
).
6.
Remove the palm rest assembly (see
Removing the Palm Rest Assembly
).
7.
Remove the display assembly (see
Removing the Display Assembly
).
8.
Remove the middle cover (see
Removing the Middle Cover
).
9.
Lift the connector latch and pull the pull-tab to disconnect the VGA connector cable from the connector on the system board.
10.
Remove the two screws that secure the VGA connector board to the computer base.
11.
Lift the VGA connector board off the computer base.
Replacing the VGA Connector Board
1.
Follow the instructions in
Before You Begin
.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
screws (2)
2
VGA connector board
3
VGA connector cable