Dell XPS 710 - Manual (Page 24)

Removing and Installing Parts: Dell XPS 700 Service Manual
parts.htm[4/11/2014 11:32:11 AM]
NOTE: This slot
is not available
in the dual-
graphics
configuration
(SLOT4)
16 PCI card slot (SLOT5) 17 PCI card slot
(SLOT6)
18 PCI-Express
x8 card slot
(SLOT7)
19 RTC reset jumper (RTCRST) 20 battery socket
(BATTERY)
21 password
jumper
(PASSWORD)
22 power connector (POWER2) 23 floppy drive
(DSKT)
24 card cage fan
connector
(FAN_CAGE)
25 processor fan connector (FAN2_CPU)
NOTICE: The FAN2_CPU connector is not
currently used on this system and is reserved
for future use. Do not attach the primary CPU
fan to the FAN2_CPU connector.
26 primary
processor (CPU)
27 processor fan
connector
(FAN1_CPU)
Memory
You can increase your computer memory by installing memory modules on the system board.
Your computer supports DDR2 memory. For additional information on the type of memory supported by your computer, see
Memory.
DDR2 Memory Overview
DDR2 memory modules should be installed in pairs of matched memory size and speed. If the DDR2 memory modules
are not installed in matched pairs, the computer will continue to operate, but with a slight reduction in performance.
See the label on the upper-right or upper-left corner of the module to determine the module's capacity.
NOTE: Always install DDR2 memory modules in the order indicated on the system board.
The recommended memory configurations are:
A pair of matched memory modules installed in DIMM connectors 1 and 2
or
A pair of matched memory modules installed in DIMM connectors 1 and 2 and another matched pair installed in
DIMM connectors 3 and 4