Dell XPS 710 User Manual
Page 61
Removing and Installing Parts: Dell XPS 700 Service Manual
parts.htm[4/11/2014 11:32:11 AM]
CAUTION:
Your computer is heavy and can be difficult to maneuver. Seek assistance before attempting to
lift, move, or tilt the computer and always lift correctly to avoid injury; avoid bending over while lifting.
CAUTION:
The computer stand should be installed at all times to ensure maximum system stability. Failure
to install the stand could result in the computer tipping over, potentially resulting in bodily injury or
damage to the computer.
NOTICE:
To avoid electrostatic discharge and damage to internal components, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface on the computer chassis.
1. Ensure that all cables are connected, and fold cables out of the way.
2. Ensure that no tools or extra parts are left inside the computer.
3. Pivot the cover down and into position.
4. Press down on the cover until it clicks into place.
NOTE:
The computer cover should easily snap into place; however, if necessary, pull back on the cover release
latch until the cover is completely closed, then slide the release latch forward to secure the cover.
1
computer cover
2
cover hinge tabs
3
hinge slots
5. Carefully, lift the rear of the computer and slide the stabilizing feet outward into the open position.
6. With the help of an assistant, carefully set the computer upright.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.