Front i/o panel – Dell Dimension 5150C User Manual
Page 36
Removing and Installing Parts: Dell Dimension 5150C Service Manual
file:///T|/htdocs/systems/dim5150C/en/sm/parts1.htm[10/31/2012 8:21:07 AM]
set the screws aside.
8. Replace any components and cables that you removed from the system board.
9. Reconnect all cables to their connectors at the back of the computer.
.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
11. Connect your computer and devices to electrical outlets, and turn them on.
Front I/O Panel
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in your
Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
2. Open the
3. Remove the
, any installed
, and any components that restrict access to the system board.
4. Remove the system board.
NOTE:
Depending on your computer, you may have one or two screws that secure the front I/O panel.
5. Remove the two screws that hold the front I/O panel.
6. Pivot the I/O panel toward the back of the computer and lift to remove.
7. Disconnect any cables that are attached to the front I/O panel.