Dell Dimension 5150C - Manual (Page 64)

System SetupDell Dimension 5150C Service Manual
file:///T|/htdocs/systems/dim5150C/en/sm/syssetup.htm[10/31/2012 8:21:30 AM]
2. To clear the password, remove the jumpers from pins 1 and 2.
3. Replace the computer cover.
4. Connect your computer and monitor to electrical outlets, and turn them on.
5. After the Microsoft® Windows® desktop appears on your computer, shut down the computer.
6. Turn off the monitor and disconnect it from the electrical outlet.
7. Disconnect the computer power cable from the electrical outlet, and press the power button to ground the system
board.
8. Remove the computer cover .
9. Locate the 3-pin password jumper (PSWD) on the system board and attach the jumper to pins 1 and 2 to re-enable
the password feature.
10. Replace the computer cover .
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
11. Connect your computer and devices to electrical outlets, and turn them on.
Clearing CMOS Settings
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
1. Follow the procedures in " Before You Begin ."
2. Remove the computer cover .
3. Remove the hard drive.