Replacing the stand assembly, Procedure – Dell Inspiron 20 (3048, Early 2014) User Manual
Page 19
Replacing the Stand Assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer
computer, follow the instructions in
. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
Follow the steps below to replace either the stand base or the stand riser:
1
Slide the stand base into the slot on the stand riser.
2 Tighten the captive thumbscrew and fold the screw handle on the stand
base.
Follow the steps below to replace the stand assembly:
3 Slide the tabs on the stand assembly into the slots on the back cover.
4 Replace the screws that secure the stand assembly to the display-panel
base.
5 Slide the tabs on the stand cover into the slots on the back cover and
snap the stand cover until it clicks into place.
19