Dell Inspiron 20 (3048, Early 2014) - Manual (Page 81)

Replacing the Camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer . After working inside your
computer, follow the instructions in After Working Inside Your
Computer . For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Slide the camera under the tab on the camera bracket and align the
screw hole on the camera with the screw hole on the camera bracket.
2 Replace the screw that secures the camera to the camera bracket.
3 Connect the camera cable to the camera.
4 Turn the camera assembly over and align the screw holes on the camera
assembly with the screw holes on the display bezel.
5 Replace the screws that secure the camera assembly to the display bezel.
6 Slide the touch-control board cable (optional) and display cable through
the slots on the display-panel base.
7 Align the screw holes on the display-panel base with the screw holes on
the display bezel and snap the display-panel base into place.
CAUTION: Make sure that no cables are placed under the display-
panel base.
8 Replace the screws that secure the display-panel base to the display
bezel.
9 Connect the converter-board cable to the display panel.
10 Connect the control-buttons board cable to the control-buttons board.
11 Route the touch-control board cable (optional) and connect the cable to
the system board.
12 Route the speaker cable through the routing guides on the display-panel
base and connect the speaker cable to the system board.
13 Route the camera cable through the routing guides on the display-panel
base and connect the camera cable to the system board.
14 Slide the display cable into the connector on the system board and press
down on the connector latch to secure the cable.
81