Dell PowerEdge VRTX - Manual (Page 125)

Figure 85. Removing and installing the power pass-through board
1. release pin 2. power pass-through board holders (2)
3. PDB connector 4. power pass-through board
5. metal standoffs (3) 6. power pass-through board bracket
Installing the power pass-through board
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1. Align the slots on the power pass-through board bracket with the metal standoffs on the chassis, and lower the
board into the chassis.
2. Grasping the power pass-through board with the holders, slide the board toward the back of the system until the
connector engages with the midplane.
When firmly seated, the slots on the power pass-through board bracket get locked with the metal standoffs and the
release pin clicks into the chassis slot.
3. Reinstall the following:
125