Qmark HT Smart Series - Digital Programmable Wall Heater User Manual
Page 5
MAINTENANCE
Your heater is designed for years of trouble-free operation and
requires no special maintenance other than occasional cleaning.
The motor is permanently lubricated.
Cleaning
Once each year, the heater should be cleaned to remove dust
and other foreign material which has collected during the heat-
ing season, as follows:
1. Turn power off at main switch.
2. Remove bottom bezel and the two screws that hold the grille.
3. Use vacuum cleaner with brush attachment to remove dust
and dirt that has accumulated in heater (especially around
element and blower blade). Do not use water or any cleaners
to clean heater components.
4. Replace grille and bottom bezel.
5. Wipe grille clean with a damp cloth. DO NOT use waxes or
any cleaners that leave a residue since these may discolor
during heater operation.
6. Turn the main line switch on at the switch panel to restore
power to heater. The heater is now ready for another season
of operation.
ALL OTHER SERVICING SHOULD BE PERFORMED BY AN
ELECTRICIAN OR QUALIFIED PERSON
5
Ref
Part Number
No.
Description
120V
240V
1.
Grille panel only
2501-11003-000
2501-11003-000
2.
Electronic Assembly
1016-11035-001
1016-11035-001
with top bezel
3.
Motherboard, triac/heat sink, ribbon connector,
1414-11007-000
1414-11007-001
and sensor assembly (in one box):
4.
Bottom bezel
1219-11004-000
1219-11004-000
5.
Motor assembly
1225-11001-000
1225-11001-001
6.
Manual Reset
4520-11005-000
4520-11005-000
7.
Heating Element
302023802
302023805
8.
Red lamp
3510-2017-000
3510-2017-001
9.
Remote Control
1414-11017-000
1414-11017-000
10
Battery
1218-11003-000
1218-11003-000
1
2
3
4
5
6
7
8
10
REPAIR PARTS
Repair Parts List
9