Qmark MUH35 - Unit Heater - Manual

MUH35D
Fan-Forced Unit Heater with
Built-in Thermostat
WHEN USING ELECTRIC APPLIANCES, BASIC PRECAU-
TIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PER-
SONS, INCLUDING THE FOLLOWING:
1. Read all instructions before installing or using this heater.
2. This heater is a commercial/industrial product not intended
for use in a residential setting.
3. This heater is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces. Keep combustible materials,
such as furniture, pillows, bedding, papers, clothes, etc. and
curtains at least 3 feet (0.9 m) from the front of the heater.
4. Extreme caution is necessary when any heater is used by or
near children or invalids and whenever the heater is left
operating and unattended.
5. This heater has hot and arcing or sparking parts inside and
is not intended for use in hazardous atmospheres where
flammable vapors, gases, liquids or other combustible
atmospheres as defined in the National Electrical Code are
used or stored. Failure to comply can result in explosion or
fire.
6. Do not operate any heater after it malfunctions. Disconnect
power at service panel and have heater inspected by a rep-
utable electrician before using.
7. Do not use outdoors.
8. To disconnect heater, turn controls to off, and turn off power
to heater circuit at main disconnect panel.
9. Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock, fire,
or damage to the heater.
10. To prevent a possible fire, do not block air intake or exhaust
in any manner.
11. Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons.
12. This heater is provided with a buzzer that will sound only if
the heater has turned off as a result of overheating. If you
hear the buzzer, immediately turn the heater off and inspect
for any objects on or adjacent to the heater that may have
blocked the airflow or otherwise caused high temperatures
to have occurred. DO NOT OPERATE THE HEATER WITH
THE BUZZER SOUNDING.
13. This heater is not intended for use in special environments.
Do not use in damp or wet locations such as marine or
greenhouse or in areas where corrosive or chemical agents
are present.
14. When installing, see INSTALLATION INSTRUCTIONS for
additional warnings and precautions.
15. For safe and efficient operation, and to extend the life of your
heater, keep your heater clean - See MAINTENANCE
INSTRUCTIONS.
SAVE THESE INSTRUCTIONS
!
Installation, Operation & Maintenance Instructions
WARNING
IMPORTANT INSTRUCTIONS
ECR 39423 04/13 5200-11128-000
Specifications
Model No Volts Watts Amps Weight
MUH35D 240 5 kW High 21
3.3 kW Low 14 22 lbs
208 3.7 kW High 18
2.5 kW Low 12