Qmark 760L General Home/Kitchen Fans - Manual (Page 2)

TOOLS
Installation of your Marley product is easy. No special technical knowledge is needed and only a few ordinary
tools are required:
Screwdriver
Hammer
Saber saw, Keyhole saw, or Jig saw
Electric drill with bit
Wire cutters
Wire stripper
Wire nuts and general electrical supplies
Safety glasses
Ruler and straight edge
All hand tools should be insulated. Power tools should display the UL Listing Mark.
NEW HOME INSTALLATION
1. Provide round hole, 9 1 /
8
” diameter, in finished wall or ceiling.
2. Attach brackets to sleeve with screws provided in brackets. Nail or screw brackets to joists. See Fig. 2
3. Adjust sleeve so that flange will be flush with the finished ceiling.
4. Pull power cable through outlet box opening. Attach cable to outlet box, using an approved
connector. Splice cable to receptacle leads in outlet box cover. Ground wire may be attached to
grounding bolt in outlet box. Power line should run to switch box holding toggle. See Fig. 3
5. Push outlet box and outlet cover into place and fasten with screws.
6. Install motor blade assembly by engaging keyhole slots over screws in fan. Then twist and
tighten, making sure that blade is centered in sleeve. The motor mounting studs act as a vernier
adjustment. If the blade strikes in line with the motor bracket, the opposite nut can be tightened to
compensate. Be sure power is off, then insert plug into receptacle.
7. Attach grille with knob.
8. Finish installation by adding sufficient 7” pipe to go through the roof and installing a Marley Model
AD1106 Roof Cap. See Fig. 4
TO INSTALL IN EXISTING HOMES
1. Determine location of ventilator. Check ceiling for joists and obstructions.
2. Draw a circle 9
1 /
8
” in diameter at determined location. Be sure opening is at least 1” from joist.
3. Carefully saw opening in plaster. Remove just enough insulation to allow sleeve to pass through.
4. After attaching mounting brackets to sleeve, nail or screw brackets to joists, or simply support sleeve
by resting mounting brackets on lath or other ceiling material.
5. Adjust sleeve so that flange is flush with finished ceiling.
6. Pull power cable through outlet box opening. Attach cable to outlet box, using an approved
connector. Splice cable to receptacle leads in outlet box cover. Ground wire may be attached to
grounding bolt in outlet box. Power line should be run to switch box holding toggle. See Fig. 3
7. Push outlet box and outlet cover into place and fasten with screws.
8. Install motor blade assembly by engaging keyhole slots over screws in ventilator. Then twist and
tighten, making sure that blade is centered in sleeve. The motor mounting studs act as a vernier
adjustment. If the blade strikes in line with the motor bracket, the opposite nut can be tightened to
compensate. Be sure power is off, then insert plug in receptacle.
9. Attach grille with knob.
10. Finish installation by adding sufficient 7” pipe to go through the roof and installing a Marley Model
AD1106 Roof Cap. See Fig. 4.
- 2 -