Sony MDS-302 - Manual (Page 23)

Labeling Recordings (Title
Function)
You can create titles for your recorded MDs and
tracks. Titles — which may consist of uppercase and
lowercase letters, numbers and symbols for a
maximum of about 1,700 characters per disc — appear
in the display during MD operation.
KKl AMS W>H EDIT/NO YES
T--I
L &
0
© (j) ■ 0
Use the following procedure to label a track or an MD.
You can label a track while it is playing, pausing or
recording. If the track is playing, be sure to finish
labeling before the track ends. If the track ends
before you've completed the labeling procedure,
the characters already entered are not recorded and
the track will remain unlabeled.
Press EDIT/NO repeatedly until "Name in ?"
appears in the display, then do the following:
To label Make sure that the recorder is
A track Playing, pausing or recording tlu'
track tk) be labeled
An MD Stopped
2 Press YES.
A flashing cursor appears in the display.
\ I / 4 5
- 6 7 8 9 10
11 12 13 14 15
16 17 18
3 Turn AMS to select the first diameter.
-: d :
4 S
6 7 8 9 10
11 12 13 14 15
16 17 18
The selected charactor flashes.
Letters, numbers, and symbols appear in sequential
order as vou turn AMS.
You can use the tollowing svmbols in titles:
! " # $ L & '
Editing Recorded MDs
Press AMS to enter the selected character.
The cursor shifts rightward and waits for the input
of the next character.
V I , 4 S
6 7 8 9 10
11 12 13 14 15
16 17 18
04.:-
5 Repeat Steps 3 and 4 until you have entered the
entire title.
If you entered the wrong character
Pre.ss or ►► until the character to be corrected starts
flashing, and repeat Steps 3 and 4 to enter the correct
character.
To erase a character
Press or ►► until the character to be erased starts
flashing, then press EDIT/NO.
To enter a space
Press AMS or ►► while the cursor is flashing.
6 Press YES.
This completes the labeling procedure and the title
appears on the left side of the display.
To cancel labeling
Press ■.
Note
You cannot label a track or an MD while vou an- recording
over an existing track.
Labeling tracks and MDs with the remote LX
Use the following procedure to label a track or an MD
with the remote.
NAME ■
Ça ajga [
gp aa m GO [
J LGJ go LO [
,a„a.
Lp IpJ gp CD [
cm op C3D ca t
Cp CSJ CE
'o q | cp a
ac te ж Ь&
El L J L J
IS i! a::cPCpS
SI S DSOD iSl (53
Alphabet/number
buttons
■ CLEAR
■ NUM
■CAPS
1 Press NAME repeatedly until a flashing cursor
appears in the displap then do the following;
To label Make sure that the recorder is
A track
An .Mi )
Playing, pausing or recording tlio
Irack to be labeled
Stcq^pec
(Continued)
23