Step 2: setting up the base phone (continued), Notes, Tips – Sony SPP-M502 User Manual
Page 10: To connect the base phone to two separate outlets, To an ac outlet, To the telephone outlets, To "l1/l1+l2, Telephone line cord (supplied), Line 1, Line 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
step 2: Setting up the base phone (continued)
Notes
• Use only the supplied AC-T48 AC power adaptor.
Do not use any other AC power adaptor.
• Connect the AC power adaptor to a continuous power supply.
• Place the base phone close to the AC outlet so that you can easily
unplug the AC power adaptor.
Tips
• If your telephone outlet is not modular, contact your telephone service
company for assistance.
• LI is the first phone line connected to center pair of wires. L2 is the second
phone line connected to outer pair of wires.
To connect the base phone to two separate outlets
4'^ 3
To an AC outlet
Polarity of the plug
Modular
LI
L2
» «
To "L2/DATA"
To the telephone
outlets
2 AC power adaptor (supplied)
O
To "L1/L1+L2"
Telephone line cord (supplied)
Line 1
D
Line 2
Telephone line cord (supplied)
1
/
2
3
Connect the telephone line cords to the
"L1/L1+L2" and "L2/DATA" jacks and to the
telephone outlets.
Connect the AC power adaptor to the
"DC IN 9V" jack and to an AC outlet.
Fully extend the antenna. Make sure it points
towards the ceiling.
10^" Getting started