Sony SPP-205 - Manual (Page 13)

Basics
Making calls
1
2
3
Press C talk ) or pick up the handset
from base phone.
The TALK/ВАТТ LOW lamp on the
handset and the LINE lamp on the
base phone light up.
Then you will hear a dial tone. If you
hear beeps, move closer to the base
phone.
Dial the phone number.
When you are done talking, press
(OFF) or replace the handset on the
base phone.
The TALK/BATT LOW lamp on the
handset and the LINE lamp on the
base phone go off.
• If you hear five short error beeps when you press ( channel ), move closer to
the base phone.
Notes
• Before dialing, make sure you can hear the dial tone, otherwise you cannot
dial correctly.
• When the TALK/BATT LOW lamp lights up by pressing ( talk ). the LINE
lamp on the base phone lights up simultaneously.
• If you press (TALK) whild dialing or storing numbers on the base phone, you
will hear a busy tone.
If the handset battery becomes weak during a call
You hear a beep and the TALK/BATT LOW lamp on the handset
flashes.
The call will disconnect soon. Replace the handset on the base phone to
charge.
n
fi»
!S.
К
(A
Additional tasks
To Do this
Put a call on hold Press T hold ).
The TALK/BATT LOW lamp flashes slowly.
Press (TALK) to resume the conversation.
Improve reception Press /CHANNEL)*.
Adjust the handset volume Set the VOL switch.
Switch to tone dialing temporarily Press (*TONE) after vou are connected. T he line
will remain in tone dialing until disconnected.
continued
Basics 13'"