Sony DHC-MD333 - Manual (Page 33)

Marking track
numbers
The irack numbers can be marked as follows;
• Mark the track numbers automatically.
When you record from this system's CD
(digital recording) or during level-synchro
recording, the track numbers are
automatically marked.
* At any point while recording.
You can mark the track numbers while
recording any sources.
Marking track numbers at
a specific point while
recording
— Levet”Synchro Recording
The "LEVEL-SYNC" is factory set to ON and
the track numbers are automatically marked.
If "LEVEL-SYNC" is not displayed during
recording, turn it on as follows. Track
numbers are automatically marked when the
input signal is under a certain level for more
than two seconds and then exceeds the
previous level.
MD± MDB
1 6
OCiDii)
OOS
aa
1
Press O REC. The MD stands by for
recording.
2
Press PLAY MODE until "PGM"
and "SHUFFLE” disappear.
3
Press EDIT then press +/-
repeatedly until "LevelSync ?"
appears.
4
Press ENTER/YES.
"LevelSync ON ?" appears.
5
Press ENTER/YES again.
"LEVEL-SYNC" lights up.
6
Press MD 0"DQ.
Recording starts.
To stop recording
Press MD ■.
To cancel automatic track marking
1 Press EDIT during recording pause.
2 Press +/ - repeatedly until "LevelSync ?"
appears.
3 Press ENTER/YES.
"LevelSync OFF ?" appears.
4 Press ENTER/YES again,
"LEVEL-SYNC" disappears.
When "LEVEL-SYNC" disappears, a track
number is marked only at the beginning of
each recording.
Notes
* You may not mark track numbers automatically it
the sound source to be recorded is noisy (e.g,.
tapes or radio programmes).
• The MD recording is complete only after all the
recording information is entered to TOC at which
point TOC stops flashing and goes out. Be careful
not to disconnect the mains lead or move the deck
before this point. Before disconnecting the mains
lead, do the following;
- Remove the MD.
- Tress I / (!) to turn otf the system.
continued
3 -
(D
3
D
D
(b
n
9
fb
r>
0
3
(Q
33