A stereo fm programme is not received in stereo, Messages, Auto cut – Sony DHC-MD333 User Manual

Page 55: Blank disc, Cannot edit, Cannot rec, Disc error, Level over, Md disc full, Md no disc

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

A stereo FM programme is not received in
stereo.

• Press STEREO/MONO so "STEREO"

appears.

Periodic noise during MD reording.

• Adjust the aerial.

If other problems not described

above occur, reset the system as
follows:

1 Unplug the mains lead.

2 Hold down I / (!), then plug the mains lead

into the wall outlet again.

The system is reset to the factory settings. All
the settings you made, such as the preset
stations, clock, and timer are cleared. You
should set them again.

Messages

One of the following messages may appear or
flash in the display window during operation.

MD

Auto cut

The MD deck is pausing the recording
because silence continued for 30 seconds or
more during digital recording.

Blank Disc

The inserted recordable MD is new or all
tracks on the MD have been erased.

, Cannot Copy

You caimot make a digital recording (see

"Guide to the Serial Copy Management

System" on page 52).

Cannot edit

You tried to edit in Programme or Shuffle
Play mode.

Cannot REC

A pre-recorded MD is in the deck.

Disc Error

The inserted MD is damaged or does not

contain a TOC.

Impossible

You tried to combine from the first track on
an MD, which is not possible. You tried to
divide the first or end of the track.

Level Over

A strong signal was input during analog
recording in the TAPE function. Reduce the
recording level following the procedure,
(see "Troubleshooting" on page 54).

MD Disc Full

There is no time remaining on the disc (see
"System Limitations of MDs" on page 52).

MD NO DISC

There is no MD in the deck.

MD Protected

The inserted MD is protected against

Name Full

There is no more space to store track or
disc titles.

NEW

The MD deck stands by for recording on a

brand new MD or from the last recorded
portion.

No Name

The inserted MD has a track numbers but
no disc titles.

No Track

The inserted MD has a disc title but no

tracks.

- OVER -

You have reached the end of the last track
during high-speed search.

Push STOP!

You pressed PLAY MODE during play.

Smart Space

The signal was input again after silence
continued for 30 seconds or less during

digital recording.

TOC Reading

The MD deck is reading the TOC
information of the MD.

TOC Writing

The MD deck is writing the information of
recorded or edited contents.

Track End

You have reached the end of the MD while
adjusting the division point during Divide

-Function.

>

a

a

o*

3

3
o

3

flu

o'

3

continued

55

Advertising