Notes, Connecting two vcrs for l^pe editing – Sony KP-61XBR300 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting Two VCRs for
l^pe Editing
SKl.ECT OlIT gives you llic ability to use a
seeoud VCR to record a program being played by
the primary VCR or to perform tape editing and
dubbing.
1
Connect the VCR intended for playback using
the connection instructions on page 7 of this
manual.
2
Using an AUDIO/VIDEO cable, connect
AUDIO and VIDEO IN on the VCR intended
for recording to AUDIO and VIDEO OUT of
SELECT OUT on the projection TV.
Notes:
• Do not change the input signal while editing
through SELECT OUT.
• When connecting a single VCR to the projection
TV: if VCR LINE OUT is connected to VIDEO IN
on the projection TV, do not connect the SELECT
OUT on the projection TV to the VCR LINE
INPUT (see right). Doing so will cause program
interference and other viewing problems.
• You can select the output signal from SELECT
OUT from the SET UP menu, (see “SELECT
OUT’ on page 40)
14
Disconnect all power sources before making any connections.
(Bear of projection TV)
(Rear of projection TV)
- Indicates direction
of signal